pandc 0 Posted July 6, 2009 I got a new computer & it has vista on it. Well I can't even figure out how to FIND the com ports so I can download my SB software & get cutting again.... Would someone PLEASE tell me where to find them Thanks Peggy Share this post Link to post Share on other sites
BannerJohn 1,324 Posted July 6, 2009 Until a Vista user comes along to help, I suggest you just try one port at a time til you get one that works. Share this post Link to post Share on other sites
pandc 0 Posted July 6, 2009 I don't know how to find them....LOL Thanks Peg Share this post Link to post Share on other sites
sandman 5 Posted July 6, 2009 I think he means in the setup drop down in signblazer. Load the drawing pen in your cutter with a sheet of paper under it, Open SB and draw a small circle or square, go to the cut screen, click on setup, click on the port window at top of the setup screen. It will have a list of ports to choose from. Try one at the time and click on cut until it draws the shape. Sorry, I know you asked for a Vista user but these ideas will be better than nothing till one wonders by. Share this post Link to post Share on other sites
pandc 0 Posted July 6, 2009 I got it Thanks everybody Peg Share this post Link to post Share on other sites
montegun 0 Posted July 8, 2009 what did you end up doing to get it to cut Share this post Link to post Share on other sites
pandc 0 Posted July 8, 2009 I found the com port that it was on & changed it in the software & it cut for me. It was cutting on the other computer, so I wasn't toooooo worried. Peg Share this post Link to post Share on other sites