kneal4747 0 Posted October 1, 2007 Hi everyone, I am wanting to cut some text vertically. ( Lettering stacked on top of each other, rather than side by side). Can anyone tell me how I might do this ? Hopefully someday, I can stop asking these these crazy questions !! This Forum, has been a GREAT HELP to me. Thanks so much everyone. Share this post Link to post Share on other sites
Guest fivestar Posted October 1, 2007 I've never used Sign Blazer but can't you just type a letter then hit enter? That's how I do it using Corel Draw. Share this post Link to post Share on other sites
kenimes 42 Posted October 1, 2007 Looks like that's how it is done with SignBlazer as well. Share this post Link to post Share on other sites
kneal4747 0 Posted October 1, 2007 Thank You very much... That works. Share this post Link to post Share on other sites
frdmftr 0 Posted March 6, 2009 Ok. That is the 'simple' solution. How do you modify the 'kerning' (letter spacing)? Sample a m p l e Any thoughts, solutions, ideas? Share this post Link to post Share on other sites
Jay2703 704 Posted March 6, 2009 Ok. That is the 'simple' solution. How do you modify the 'kerning' (letter spacing)? Sample a m p l e Any thoughts, solutions, ideas? You should be able to use Node Edit to adjust the spacing. Two small boxes will appear on the bottom of the text. One adjusts the spacing between letters, the other adjusts the spacing between lines. Share this post Link to post Share on other sites
frdmftr 0 Posted March 6, 2009 Oh ya! Thanks neighbor! Share this post Link to post Share on other sites
moparmutt 0 Posted March 8, 2009 I was fixing to ask the same question. Thanks guys. By the way, search isn't working. Share this post Link to post Share on other sites