how do you cut with small scraps and issue with incomplete cuts

[Guest manwayvan]

Hey everyone I have been cuttin like crazy the past couple of days

And have aquired some scraps I would like to cut with but my roller

Goes nuts and jerks it everywhere. The scraps are not wide enough

To clamp with both rollers so I can only use one. Any advice with cutting

Scraps roughly 2 inch wide. Also I am having really small incomplete cuts on small text

And I have tried slowin speed down to 10 but still the same issue. I have pressure at 110

I am unable to search what might be the issue as I'm on my blackberry so I apologize

If these topics have been covered.

[BannerJohn 1,324]

first...you MUST use 2 rollers. If your rollers won't go close enough together to cover the smaller pieces, you have to use a carrier sheet...the kind that comes with the smaller craft cutters. Someone posted that you can get them at Walmart near the Cricut cutters. As for the incomplete cuts, you might ry adjusting the blade offset. Or if you are using Flexi,also the overcut.

[Rodger 527]

my Co-Pam has 5 drive rollers spaced so that almost any width vinyl scrap can be cut using at least 2 pinch rollers . I think there is a cutter that has a solid drive roller all the way across it

[Guest manwayvan]

I know what ya talkin bout with the cricut stuff and hadn't thought about it

But ill give it a try. Anyone have any docs about copyright stuff? I want to cut

Blackberry stuff and I know people cut copyright so how do you get around it?

[BannerJohn 1,324]

what kinds of stuff? IF you mean skins, you are fine.

[Guest manwayvan]

Prolly gonna be metallic film letters to go on cell phones like have

Blackberry in a cool font and sell em.