baysidejim 0 Posted May 17, 2009 Hello. I've been cutting successfully for months and I did something and I'm not sure what. I send a job and in the CUT/PLOT window, it says "holding" under status and I can't seem to get it to the plotter? Any suggestions would be GREAT. Thanks, Jim Share this post Link to post Share on other sites
kenimes 42 Posted May 20, 2009 When the cut preview window pops up- before you click on Send- look for a setting that needs to be set to Send Now, instead of Hold. Share this post Link to post Share on other sites
