BTN990 0 Posted April 7, 2009 Is it possible to use a straight USB connection from my computer to the USB port on my cutter? I have seen where some seem to be going from their serial port on the comuter to the USB port on their cutter, and some where they are using their usb port through a usb to serial adapter to the serial port on the cutter, but is is possible to connect directly from the usb port on the computer to the usb port on the cutter using only a usb cable? If so, where do I get the necessary drivers? Any help would be greatly appreaciated. Bruce Nicholson btn990@citystreet.com Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 7, 2009 I use a usb cable on my copam with no problem - the driver I use is the DGI OM-60 it works better than the copam driver! Share this post Link to post Share on other sites
BTN990 0 Posted April 7, 2009 Thanks, Do you know where I can get a copy of the driver? Bruce Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 7, 2009 it's in flexi already Share this post Link to post Share on other sites
BTN990 0 Posted April 7, 2009 Don't have flexi, am using Signblazer Elements Bruce Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 7, 2009 on flexi I just used the Coapm drives that came installed with the program Share this post Link to post Share on other sites
