onlyinaboat 0 Posted August 14, 2007 Everything was going great. I have used it for 30 days. My 30 day trial just ran out and we registered it for the 3 year program. Now I go to cut and it acts like it is sending to the cutter, but the cutter doesn't do anything. Help Share this post Link to post Share on other sites
CES 0 Posted August 14, 2007 Are you using the USB or the other cable? If it's the parallel cable, then is it the original or have you installed a longer one? I had a similiar problem. Some jobs would go over fine, with a longer cable, and others would not. In every case, when I have re-installed the shorter cable, it's gone over and cut. Very frustrating, since it's damn near impossible to have multiple pieces of equipment in a shop and all of it has to be within 6 feet of the computer. Might not be your issue, but thought I would mention it. Share this post Link to post Share on other sites
BannerJohn 1,324 Posted August 14, 2007 just a thought,but when you registered it,did you check your settings again to make sure that they were correct? Share this post Link to post Share on other sites
kenimes 42 Posted August 15, 2007 Probably just need to configure the correct settings to be up and running again. email me or call if you need help kenimes@uscutter.com 425-284-2282 or 866-789-2919 Share this post Link to post Share on other sites
