RESET THE PLOTTING PEN TO THE ZERO POINT

[erwinandreas 0]

HELLO MY PLOTTER GO'S FURTHER TO THE LEFT WHEN I PLOT AND EACH PLOT A LITTLE BIT FURHTER TO THE LEFT HOW CAN I SET MY PLOTTER TO THE ZERO POINT ON THE RIGHT SITE OF THE PLOTTER ? THE STARTING POINT

THANK YOU ALREADY

[hairyconiption 0]

What plotter are you using? If you are using a refine model press "offline/pause" move the carriage all the way to the right with the arrow buttons and then press "orgin". Good luck. You can use this trick the get the most out of your vinyle my doing small cuts off to the side of what ever you are doing.

[kenimes 42]

You could also press the reset button which should return the carriage to the far right position on the cutter.