CasualThreads 0 Posted August 8, 2007 I am a newbie and just purchased a Copam 2500 with SignBlazer software. Can I manually set the origin in the machine or software? For example, if I cut something 4" x 4", I have 11" yet to use (i.e. 15" wide material) or do I need to cut off my first design and let the machine reset the origin again? Thanks, Mark Casual Threads Share this post Link to post Share on other sites
kenimes 42 Posted August 8, 2007 To set the origin you want to start cutting at, just use the arrows to move tha carriage and material, then hold down on the Enter button for a few seconds. Share this post Link to post Share on other sites
CasualThreads 0 Posted August 8, 2007 OK, thanks. I knew there must be a way....just couldn't figure it out last night. Thanks again. Mark Casual Threads Share this post Link to post Share on other sites