trinic 0 Posted July 18, 2007 whenever there is a circle, such as when I cut an O, there is a little piece that I have to either cut with an exacto knife or pull, It's killing me when I try to cut names...HELP PLEASE Share this post Link to post Share on other sites
TaterNuts 3 Posted July 18, 2007 change you blade offset... I dont knwo what software you are running, so i dont know how to tell you to change it. Share this post Link to post Share on other sites
kenimes 42 Posted July 18, 2007 If you are using SignCut, the blade offset can be adjusted by going to Settings, then Cutter, and it is located towards the bottom of this screen. Default is 0.010 Share this post Link to post Share on other sites
trinic 0 Posted July 22, 2007 what should it be changed to Share this post Link to post Share on other sites
kenimes 42 Posted July 23, 2007 You could try .020, .025, .030 etc. Share this post Link to post Share on other sites