Search the Community
Showing results for tags 'notcutting'.
Found 2 results
-
Well, i recently purchased Make The Cut, which the plotter i have does support. its working, it does cut but the problem that i'm having is that whenever i send something to cut, it starts the line but then goes over to another corner or spot and starts doing jagz and zig zags , then it sometimes goes back to the work then stops. it doesn't even finish the cut. i guess it's the plotter,that since i didn't use it in quite some time, maybe the sensors are dirty or something. if anyone has or has had this same problem and knows the solution, please tell me what i can do to resolve it, attached i will leave one example of what i'm talking about. Thanks..
- 2 replies
-
- plotter
- notcutting
-
(and 2 more)
Tagged with:
-
Hello everyone. This is my first topic posted. I am posting this to see if I might get some advice on how adjust my machine. I use Oracal 651 material and I am having problems with almost every cut. No matter what I do I cant seem to get the machine to cut objects, letters, etc 100% for example, it will cut designs fine but when I begin to weed i start to see that at certain corners of letters or shapes, it will not have cut a smidge. So it the letters will try to lift since it has a corner that hasnt been completely cut. This is extraordinaly frustrating. I have Sign Blazer trial and the blade off set is set to .25mm I have tried tightening the blade belt and still no luck.
- 6 replies
-
- mh365
- notcutting
-
(and 1 more)
Tagged with: