jason581

ok i know you have to vector the image before the cutter can do its thing. I was going to purchase the vector magic program because its the best and fastest. but i was wondering how is the image saved? as a jpeg, etc? how does it know it has been vectored in another program?

when i go to print the image which registration marks do i use? meaning what corner to put it in. does it matter?

that just got rid of the update not the countdown

So i plugged in the usb to a different port in my computer and it found the ftdi file. It works Finally. thanks guys for the help!! now can you answer y i need to wait for a count down to open trial mode

Y every time i open signblazer the trail button has a countdown that increases by 1 every time i open and close??;D?

it says thats for a mh series i have a laser point

i also get a software is not compatible with this driver error

When i go to plug in the usb the computer automatically starts looking for the device and fails, when i go to manualy install the drivers it says somehting to the effect of these drivers not supported by windows 7 64 bit. i purchased a usb to serial to try that and still nothing. Lueman when i go to the device manager there is nothing that states serial port. Also y is it that every time i start SBE the trial has a count down which increases every time i open the program?

ok i have a 24" LP, and i laptop running windows 7 64bit. when i connect the cutter using usb it installs the driver automatically but just the the usb to serial driver. how to i install the cutter driver. it does not show up in the device manager. and when i try to install the drivers from the cd it says something about windows 64 bit not supported. Is there no support for windows 7 64 bit using this cutter???