VictoryVinyl

Thank you so much! You guys are amazing!!!

Can anybody help me with this? I found a couple similar but the "l" and the angle of the ends of the "s" get me. Thank you Bennie

OWJones If that was the case she would have put me out on the street years ago!!! lol

I used one of mine today. Set up a new blade for cutting sandblast mask. No issues so far (fingers crossed!)

She did go with me to the NBM Show, so she has seen a little. lol Its not often that she is interested in things like this that I do so it could be a good thing. I'm feeling way behind the power curve though. Everything else that I have done I have done a ton of research beforehand, this I haven't, seems a bit intimidating but I'm excited. Bennie

Thats one of the reasons I went ahead and bought from them. Them seem to have very good tech support and very helpful. I met those guys too and talked to them for quite awhile. I luckily already had the heat press so that definitely helped me make my decision to jump in. Bennie

Well I do vinyl decals and love sand carving but now (thanks to the wife pushing) I am now jumping into the world of sublimation. I'm sure I am going to have a crap load of questions! I just bought a cheaper sublimation printer from Conde so we will see. Basically I'm just here apologizing in advance for all the future questions. Bennie

All 3 of mine seem to be ok. Setting up a new blade for some sandblast mask this week will have better review later this week. Bennie

I got my 3, came from 2 different locations. Still need to take a good look at them! Bennie

I was just going to post this. Order 3 myself today! Bennie

I , somehow, also missed the US Cutter booth.

Yes, me too. Starting Wednesday.

Are you taking any classes while there?

I'll be there Wednesday through Saturday. Bennie

Thank you both! I'll check them out