Koda

and natrually it says all my files are to large. so ill post up more as soon as i get them resized.

Not new to the forums but decided I'd show some of my work. Open to any advice to advance my abilities so any help would be appreciated.

Thanks again, first time out in a long time was a success.... Now I'm back to the drawing board on trying to remember how to resize pics

First run out was a success after I set my blade a slight bit deeper.... Pretty much had to hand cut the "Koda" part. Would have just cut another one but rather than waste it may make me pay more attention next time. Again thanks to you for helping. I'm sure ill be back in with more questions about this software. Thanks again

A huge thanks to mzskeeter on helping me out on this so fast. Registration complete finally!! Very painstaking, could definitely be practice for a locksmith job. Too late to try it out, I know I'd be up all night trying it out if it works. I'll post an update tomorrow after work if this is a yay or nay situation. Again thanks to all who assisted me so fast.

Thanks skeeter I appreciate it. I retreated to taking my son to the bowling alley before I decided to dismantle the cutter lol. I will try this as soon as I make it home. Again I greatly appreciate the prompt help you have provided.

Ok didn't know I needed to activate the software. Is it capable of being activated with out Internet as the only Internet I have is on my phone? That could very well be my issue, just had never ran across an issue like this. Thanks

Attempt to post pic

Hello guys not new to vinyls but new to scalp3 software version 3.052. I have been trying to get my mh871-mk2 to not cut lines across my fonts. It looks reminiscent of our kids handwriting tablets line. I've tried serial cable, USB & 2 different computers. No dice so far. Any help would be appreciated, I've taken pics and will try to upload them, if not ill have to send them to someone to upload. Thanks in advance