4DPrinting

I am using XP It says it can't find better driver software than I already have - So i uninstalled the serial converter which is the port that the cutter is plugged into via USB. I try to plot w/ the COM 3 option which is the serial converter. And I get a precent that's plotting which is 0% and nothing happens.

I just ran that through - and I uninstalled it. Now the .exe file in it is running me through the uninstal process again and the error shows up that a file is missing that is also in the cd so i copied that put it in the cwindowssystem32 folder it said it uninstalled it - then i go back to re install and the same thing happens.- claims the file is missing to uninstall..

USB - direct connection. This is a PC and I am running flexi sign pro 8.1 Kenimes suggested this - Instead of selecting each COM port, just verify which one it is acutally using in the Ports category of your Device Manager. I Know that the serial is running off of com 2, and i ran through each com trying to connect via USB. And it didn't run through.

I have no other serial cable right now - The cable is no more than 4 months in use though. I went through the process of all 10 COM's available to attempt in getting the plotter hooked up through the USB cable. And it was a no go. Any new suggestions..

Ok - I went through a few, and figured it would be labeled USB and it just wasn't there - assumptions. I will do what's suggested - then message back. Thanks!

I've been cutting w/ the serial port for months and up until last week it started having issues sending through to the plotter as quick as it used to. Now it claims a "write port error". So my solution would be switch to USB connection? - But it seems I can't find the option to switch that. Let me know if anyone can be of assistance. Thank you!

also, can you please post weather this worked for you or not, this way if it doesnt, i will stop telling people to do it. - It does not work.

The PM is sent. Thank you!

It is not.

The plotter was cutting, now in the production manager of flexi sign it goes through the process of how much percentage is cutting, but the plotter is not cutting when it shows this progress. Also, when it was cutting it was missing small cuts along the pass.. Can anyone be of assistance please..?