I<3Cookie

I unscrewed the thumb screw when I did those pictures and screwed it back in to take the pictures.

I know the edge of the plotter pen and blade holder is supposed to sync with the base but as much as I tried to push it down it just stops half way

No I tried pushing it down some more and that's how far it goes. I tried stretching out the bottom base but it felt like it was going to snap.

Hi everyone! I have the Pcut 630 laserpoint cutter I'm not exactly sure if it's the same as the Uscutter laserpoint version, this is my new cutter. I figured out how to vectorize the images and send it to the cutter from my computer, but the problem is that the blade holder doesn't seem like it really fits. I'm not sure if I installed the one that came with it correctly; or if I'm supposed to use the roland blade holder. Thanks for helping! I have included pictures of what the blade holder/plotter pen looks on the cutter right now. http://imageshack.us/g/37/dsc06344k.jpg/

Thank you mabscotthandyman, and Ash Computers.

Hello my name is Jen, I'm trying to find a vinyl cutter with contour cutting for a small business. However I cannot afford a Roland or Graphtec so I was looking into two different cutters. The two cutters I had in mind was the Uscutter laserpoint 24 and Professional Creation PCUT CTO630, any other cutter suggestions would be greatly appreciated. I know the Uscutter laserpoint uses signcut and the Pcut uses Flexistarter is there anything else that is different between the two cutters? Thank you very much in advance:)