freemane1

I also heard to use a rivet brush to get in the grooves on the coraplast

They say to set your offset to 25 which I did and really don't have an issue like that. As far as your other question when you go into cut the weed box is in the lower left corner just uncheck one or both.

They have several font find programs so maybe you can locate one that will help you out.

I would think a band saw would work great for that as a last resort. It has a very thin blade and doesn't saw real fast so the heat wouldn't be much of a factor.

That looks real nice. My first job is coming up and it's going to be a banner for a mortgage company.

I bought 8 rolls 24" x 10 yds from vynil_windowtint_supply and it is actually not usable. It gets tunnels the full width of the vinyl and several of then as it unrolls. If you try to cut anything it just pulls the vinyl up. I emailed them and told them the problem and all they had to say was sorry for the inconvience. Also the colors are all flat not glossy.

I noticed my Pcut not cutting right either. It really hasn't caused any big problems but it is a problem when weeding. I have been thinking it is the cutting strip but I haven't ordered a new one yet. My cutter has hardly been used since I got it.

Who does one get ahold of to buy a stand for a Pcut and how much do they cost?

Krylon clear coat will not hurt your vinyl. You can even paint on the vinyl with color coats.

Hi I am new here and I was also worried about the tracking of the vinyl. I went to the web site that is listed here for a stand and couldn't find one listed. Are there other places to find one. By the way I have the Creation Pcut 24 inch.