Leaderboard

0. I've been enjoying using my LaserPoint 48" Vinyl Cutter on & off for the last 3 yrs, but I distinctly see needing some digital ink printed vinyl, esp for partial car wraps. 1. What is the best price anyone's seen for printed vinyl (& laminated) (that you can use for wraps)? I can always get a good image to use & enlarge it with minimal pixelization from umpteen family jackets, home made blinds etc., so... 2. What is the best price anyone's seen for pre-printed camo (car wrap)? The best price I've seen for mossy oak camouflage is $4.125 per sq ft on a Sheet Size: 2 feet x 4 feet (8 sq ft) ($33/ 8 ) . http://www.powerspor...ps/503/infinity price est chart by vehicles http://www.powerspor....com//chart.php 3. Any advice/ heads-up's I should know of (like air channels, etc)? Thanks kindly!

Does it really have that stuff in it YIKES .... I have not been HACKING at all lately . That sounds real bad , but so does " eating dead chickens " .

Then when you install the holder , test cut WITH plenty of pressure ...& adjust blade depth to where there is barely a mark in the backing paper . I suggest at least 90 grams pressure . USCutter lists genuine Roland blades , but not in stock today ... $15 each . I cut with low pressure starting out , using that to adjust the cutting depth . It was very inconsistant . After reading Ken advise to use minimum 100 grams of pressure & adjusting the blade less & less ( MUCH less than 1/2 of a credit card ) , perfect cutting . Edit ; mb20music .. add a " s " & you would be correct

Welcome aboard!

Try using a hair dryer to warm everything up a bit. I lay vinyl down on some of my airbrush projects and it comes right back up with a bit of warmth, also same for making it stick. Did a decal on a car window the other day it was near 20 degrees outside it went right on and tape came off clean. Hope this helps