AkeeLaMor 0 Posted March 15, 2020 We purchased a Graphtec ce6000-40 from another individual. She did a factor reset and provided the installs via usb drive. I did the multi install but I cannot get the graphic plotter and laptop to see one another. I get a connection error 1121 when opening the Graphic Cutting Control Plotter. Initially I was receiving a driver error but after doing a printer type install and selecting the driver that resolved. Any ideas on error 1121? Dell Windows 10 laptop 64bit Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted March 15, 2020 I use the Graphtec cutting controller and on mine, the vinyl cutter has to be on, and ready to send the cut from the cutting software. It will not open, until the Load media> Enter, roll> enter. and the cutter is ready to cut the design. Your not mentioning what cutting software you are using. You have to set the vinyl cutter up to the cutting software. User manual is online. 1 Share this post Link to post Share on other sites
TEES ON U 0 Posted September 8, 2021 i had exactly same problem when i wanted to set the conditions thru graphtec cutting controller. i am using w10,corel draw X9,graphtec pro studio and cut master 4. how do i solve this issue? Share this post Link to post Share on other sites