Sign in to follow this  
ahgrafx

Plotter rounding corners and not finishing

Recommended Posts

Is this a new cutter to you?  Doesn't look to be set up correctly. How did you set your blade?  And what is the blade offset at? It has nothing to do with baud rate.   Your baud rate should be 9600. 

Share this post


Link to post
Share on other sites

check offset and maybe slow the cutter down.

if you can, try to vectorize the text and see what's happening with the nodes.

Share this post


Link to post
Share on other sites
11 hours ago, MZ SKEETER said:

Is this a new cutter to you?  Doesn't look to be set up correctly. How did you set your blade?  And what is the blade offset at? It has nothing to do with baud rate.   Your baud rate should be 9600. 

just went to check blade offset and that is exactly what it looks like is incorrect, performing the calibration now.

carriage wheels track?? my understanding is the wheels can go anywhere except where the "brackets' are located? is this not correct?

not a new cutter ut this is the first time I have used it for text.

the text is vector.

ill let you know how the calibrations goes.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this