timshaw64 0 Posted July 14, 2015 Hi Guys Hope someone can help ! Updated to Illustrator CS6 in my IMAC also updated to cutting master CS3. The Graphtec cutter is connected using a KEYSPAN USB to Serial convertor Using CS4 and CM2 the cutter connects abd cuts without any problems. In CS6 and CM3 the cutter will not connect / sync. My questions are..... Is the FC3100 compatible with CM3 ? Do I need to update the FC3100 firmware ? Although the cutter works OK vis CS4 and CM3, do i need to update the Keyspan drivers? Any help in this matter will be greatly appreciated. Regards Tim Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted July 14, 2015 Graphtec tech support can help you...Give them a call... They should be more in tuned on if newer software will work with older vinyl cutters Share this post Link to post Share on other sites
Jburns 239 Posted July 14, 2015 My FC7000 will not work thru CM3 and CS6---I called tech support and they said the FC7000 will only connect thru CM2. 1 Share this post Link to post Share on other sites
timshaw64 0 Posted July 16, 2015 Hi Guys Thanks for the help. Found the CM2 version thats is compatible with CS6 and the FC3100, so should be Ok for a while now. Thanks Share this post Link to post Share on other sites