krissyjessop 0 Posted June 8, 2014 I have a Copam CP-2500 cutter... the last few times I've used the cutter, the text is "off" at the end of my "sayings". Kinda of hard to explain so please see attached pic. After OF, the next section of the saying is raised higher. That's not how I have it in the Sure cuts software. Not sure why it's all of a sudden doing this but I need it fixed ASAP. Please advise! THANK YOU Share this post Link to post Share on other sites
signyouup 178 Posted June 8, 2014 What direction is the text in relation to the cutter? Is the picture what you would see if standing in front of the cutter? Share this post Link to post Share on other sites
krissyjessop 0 Posted June 8, 2014 I think I figured it out... my roller was in the way. haha. Still learning. Share this post Link to post Share on other sites
signyouup 178 Posted June 8, 2014 We've all done something. Share this post Link to post Share on other sites
Wildgoose 4,200 Posted June 9, 2014 Yep, been there and done that myself. I was cutting fine sand then slid my pinch roller over to where it wasn't over a friction spot on the drive shaft and everything went real bad. Share this post Link to post Share on other sites