theishkid 13 Posted May 28, 2014 My second problem, and this could just be a Cutting Master problem but I don't think it is. There is a small chance that I changed some setting the other day but I really don't remember doing anything. Everytime I cut something, the plotter does not come all the way back to the starting position. It's like it starts a new starting position about a half inch to the left. It creates a stair stepping effect if you will. Take a look at the pictures and let me know if you have any ideas. Thanks! Here's the starting position And here is the position after it is done with the first cut. Might be hard to tell. Take notice of the blue strip. Share this post Link to post Share on other sites
constricted 27 Posted May 28, 2014 i'm guessing you changed a setting.. i know in scalp you can set it to return to the origin point, advance a certain distance etc.. check your settings Share this post Link to post Share on other sites
theishkid 13 Posted May 28, 2014 I'll definitely check... I'm just wondering if it has something to do with my other problem. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 28, 2014 Are you by chance using scalp, only time I have seen that Share this post Link to post Share on other sites
theishkid 13 Posted May 28, 2014 Nope... Cutting Master 3. I'm about to head home and I'll run through all my settings inside it. Share this post Link to post Share on other sites
theishkid 13 Posted July 2, 2014 Just want to clear this topic, it must have been something I did as I have not run into the problem over the past month again. 2 Share this post Link to post Share on other sites