peteblade 0 Posted September 22, 2013 my cutter was cutting and seen it was going wrong so pressed pause.but now when sending a job through it says sending cutter says on line but nothing happening. Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted September 22, 2013 did you read your other post? Question was answered, an hour ago. Did you try what I said? Also make sure your com port numbers still match in your device manager and the cutting software. Share this post Link to post Share on other sites
peteblade 0 Posted September 22, 2013 no not seen it.its been working fine for ages.but after i paused it its not going but says its sending Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted September 22, 2013 please go read your other post, your question was already answered. . Duplicate posts just create confusion.. You only need to post your problem 1 time. Most people read all the NEW CONTENT.. 2 Share this post Link to post Share on other sites
slice&dice 2,450 Posted September 22, 2013 Press the pause button again, it probably will unpause. Share this post Link to post Share on other sites
