Roland PC 60 & FlexiSign Pro 6.5v3

Recommended Posts

I am using Roland PC-60 and FlexiSign Pro 6.5v3. After much trial and error I have finally gotten my laptop to recognize the parallel to USB connection. I have downloaded Roland driver and the software shows Roland. I import a purchased download of a rhinestone design (EPS) into Flexi and parse the postscript. I send it to the Production Manager thru Flexi and it processes from 0 to 100% using COM3 port......but the cutter never cuts!!!! I have checked mode in command prompt-it shows:

Status for device COM3:

Baud - 115200

Parity - None

Data Bits - 8

Stop Bits - 1

Timeout - OFF


CTS handshaking - OFF

DSR handshaking - OFF

DSR sensitivity - OFF

DTR circuit - ON

RTS circuit - OFF

Flexi has cut these designs on my brother's Roland CAMM 30" following this procedure - has to be setting errors - please help - I want to throw it out the window! I have a lot invested in downloads I can't cut or use.

Donna Redd

Share this post

Link to post
Share on other sites

using com port with parallel cable will not work. change it to the correct port.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now