Search the Community
Showing results for tags 'refine mh721'.
Found 4 results
Hi, ok so i have a refine mh721 bought second hand but not overly used before i had it. Now i have been using propely cutting various wall stickers and garment vinyls etc for about a month. Not had a single issue. Until last night Half way through a larger cut the blade got caught or some mishap that led to the blade being dragged of its track, i reset the blade on the track etc and then it seemed to be working finished the order and then went to start the next. Then the problem happened, it stopped cutting mid design and just had some funky stuff on the lcd display. So i switched the plotter on/off, on reboot, the display is now blank and all three lights are lit (red-reset, amber-online/offine, green-setup) I am gutted. I am new to plotters but have some technical knowledge that i have picked up along the way. So i have check the 'simple things' or so i believe. Any help would be GREATLY APPRECIATED! Thanks in advance
Hi, this forum has been a great aid to me over the last 5 years but maybe this time it might be my plotter is wore out. I have no down force, You can crank as much down force as it has and its like the blade is just glideing across the vinyl. I've checked to make sure the wheels are in the track , thats all good. When I use to turn it off and then turn it on the cutter head would kinda snap to attention, now it just kinda rolls the vinyl on the pinch rollers and the cutterhead doesn't move like it use to. Its will still go back and forth on the track, just no pressure. My set up Refine MH721 com3 connection flexi starter windows 7 this plotter is 5yrs old, it was bought in 07, maybe its reach its end? any help is greatly appreciated
Hello.. I've had a Refine MH721 for about 3 or 4 years and just now starting to get a little serious about using it. The problem I have is that I never know when the plotter is just going to start cutting or roll the vinyl back and then start. How do I tell what it's going to do, or what do I need to do to make it do one or the other Thanks for any help you can give me. Thanks Rick
Hello.. I've had a Refine MH721 for about 3 or 4 years and just now starting to get a little serious about using it. Also, I'm using Signblazer Elements. Everything works great all the time execpt for one thing and I'm sure I'm not doing something I should be doing... The problem is that when I tell it to start cutting I never know when the plotter is going just start cutting or roll the vinyl back and then start. How do I tell what it's going to do, or what do I need to do to make it do one or the other. Thanks for any help you can give me. Thanks Rick