Search the Community
Showing results for tags 'font cutting'.
Found 1 result
I have been working with Graphtec support for over a month trying to troubleshoot this issue and haven't gotten anywhere so I want to ask here to see if anyone has a suggestion. When I cut fonts, Really anything under 80pts The letters end up all jagged like it couldn't figure out how to connect the circles properly. Graphtec has had me reset my unit, replace the blade holder ($100 down the drain still having the problem) I have replaced the blade. Checked to make sure the holder is in there tight and also that the Pen Block isn't loose. I ran a test with the pen in instead of the blade holder and blade and it was perfect. I am running Version 1.30-STU Condition 1 - CB09U S30 F14 A2 I only run rolls of Oracal 631 indoor vinyl. Can anyone brainstorm a different solution? The 3rd photo without writing is after changing the blade holder but still slightly getting issues that you can see on the 2 and the 9, they just aren't smooth cuts.