MrMopar64

Can this plotter be used as a cutter? Also what is it worth? Thanks MM64

Just found this site thought maybe someone could use it... http://vector.us/ It's prob been around forever but hey I'm old MM64

How heavy of a static cling can I cut on a Graphtec 6000 I can only find 8mm Thanks in advance MM64

#2 you loose the roll bar so it looks more like a sedan... MM64

Sent pm

Aprintco Los Angeles Ca

Paypal has whats called VIP Access which when you log in you need the number that the program produces to enter in the box before it will open your account. The number changes every minute MM64

Lower the force a number or two MM64

If jaybird don't workout let me know MM64

If those are going on the inside of the glass they need to be cut the other way... just say'n MM64

First job this week... MM64

Thanks! Guess I should have run the center aline by them This was what they sent to me. As far as more vinyl... lets just say the budjet was tight MM64

While talking paypal here are some rules mostly about check captour and most people don't know No checks over $1000.... If your customer owes you more have them write 2 checks Daily limit for deposit is $1000 Weekly limit for deposit is $3000 If a check gets rejected by there system you can not re-deposit it If a check gets lost in ciber space in there system you have to wait 15days before you try to re-deposit Then if the system will not take the check you must get another check I have no bank account for my business and my bank would not cash a check with my co name on it That is where I learned all this Just a few things I learned the hard way MM64

I don't know much about this. I've only conture cut printed stickers But what if you made a printed layout with reg marks and put it over your tape Then use it to set up your conture cut.... Might work MM64

Yeah the plotter doesn't know the difference blade or pen my graphtec has a pen setting but when I watch it work it goes through the same thing as in the blade mode MM64

The new graphtec does the same thing but somewhere in the set up it ask if you want it made inside or outside the job The plotter does it to set the blade to start the cut... Now I don't know for sure what software is asking for this info I just set it to outside and have had no problems MM64

Solid stock will bend eaiser then tubing... heavier wall tubing would be better or another small tube that just fits inside that one MM64

There have been a few posts on here about that... mine also had bent rollers The problem is they don't stay straight even after being fixed the material is just to thin They have not caused any problems so far MM64

I've pressed wetsuits at 300 MM64

What is the percentage showing in the cut window? MM64

Send it threw Vector Magic and see what they come up with MM64

The 6000 don't use the spring... MM64

These guys will print anything you want http://www.heattransfervinyl4u.com/index.php?route=common/home MM64

Thanks I'll try that... I was using arial black all caps... they are all the same height but not what they were set to be MM64

Not sure how to fix this. I made some lettering in flexi 8.2 i think in design center I set them to be 18.5" tall. Then went to the cut window it was set at 100% cut the letters and they came out 17.875 Is there a setting in the software to correct this? Thanks MM64