PACS Man 0 Posted September 19, 2008 In the SignBlazer help, is says to add register marks for each color of a multi color graphic so you can use them to line up each subsiquent color, that you go do DRAW and select the register marks. My SB does not have that choice. Any ideas? Am I not layering correctly to get that selection? Share this post Link to post Share on other sites
RegisG 0 Posted September 19, 2008 Make 2 small squares (e.g. 1") in a different color and place them just above each top corner your image. Then select this color with each of the other colors as you cut. There are a couple videos here to sho you how to line them up after you cut & weed. Share this post Link to post Share on other sites
snlsd 1 Posted September 19, 2008 I ran into the same problem today. I think this feature is only available in SignBlazer Pro, not available in SignBlazer Elements. Share this post Link to post Share on other sites
mobby 1 Posted October 14, 2008 The express and pro versions do the rego automatically. SBE needs a manual solution such as has been suggested mobby http://www.computerandlaser.com.au/SB_Support.htm Share this post Link to post Share on other sites