dunfool 0 Posted September 9, 2008 that makes sense.. i will try that Share this post Link to post Share on other sites
dunfool 0 Posted September 9, 2008 i tried doing that.. and thats where i run into alignment problems when i hit "cutter". I made two small squares (yellow) above the "www" and the "com". as soon as the cutting screen came up, both squares were above the "m" on com. they were centered above www and com in the drewing screen Share this post Link to post Share on other sites
pogo 0 Posted September 9, 2008 When you go to the cutter screen, click the save space tab and uncheck "save space horizontally" and "save space vertically" Share this post Link to post Share on other sites
dunfool 0 Posted September 9, 2008 Thank you!!! that was the problem... Share this post Link to post Share on other sites
Jay2703 704 Posted September 9, 2008 In the cut window there are two tabs at the top left. One is called "Save Space". Make sure none of the items are checked and try your cut again. Share this post Link to post Share on other sites