RegisG 0 Posted July 28, 2008 Has anyone here tried the pcut with diamond tip for engraving? I see them advertised for Roland and supposed to fit PCUT. I don't know about aluminum (even very light) moving without having flat bed to lay on. Any good/bad experience? Thanks Regis Share this post Link to post Share on other sites
Popeye 0 Posted July 28, 2008 There is a company on ebay selling them for the Pcut.. they have a carrier and a small table.. I'd like to know if they work as well, just don't feel spending the money to find out Share this post Link to post Share on other sites
swaneejuggalo 0 Posted July 28, 2008 That looks cool i might have to try one some day Share this post Link to post Share on other sites
SmallSigns 23 Posted July 29, 2008 I wonder if it would work on the Laser Point??? This is interesting - may need more research! Share this post Link to post Share on other sites
Knobhill 0 Posted July 30, 2008 Looking at the same, still on the fence. Share this post Link to post Share on other sites
Dellrose Custom Lighting 0 Posted July 31, 2008 Does anyone have a link for these?? Share this post Link to post Share on other sites
Dellrose Custom Lighting 0 Posted July 31, 2008 thanks Share this post Link to post Share on other sites
RegisG 0 Posted July 31, 2008 I asked a seller foa any setup or pressure information. Got reasonably prompt reply with: " Use at least 180 to 220 grams slow speed and tip about 1/8 from surface" I don't know if I'm willing to crank-up my brand-spanking-new PCUT quite yet......at least until I paid for it with incom [lol] Regis Share this post Link to post Share on other sites