agile4 0 Posted July 23, 2008 How do I make the blade go down manually? I read a post about pressing the bottom left down arrow while on-line, but I have tried almost every combination of buttons - on and off-line" and can't seem to make it drop... actually it seems to be dropped at rest but lifts when moving... is this right? The reason for this is I read the PDF on adjusting the pressure and it talked about manually downing the blade while manually cutting a square until you had the right pressure. Any thought? Tom Share this post Link to post Share on other sites
kenimes 42 Posted July 23, 2008 Should be a Up and Down button on the bottom left side of the control panel, and the cutter must be at the x and y screen to use it, or in other words, Offline. Share this post Link to post Share on other sites