Kysmiley 0 Posted July 9, 2008 I have made my first text design. I have read and reread the signblazer and laserpoint directions on cutting. I feel I have done all the setup, yet when I click on the cut icon something comes up indicating the design is sent to the cutter yet the cutter does not do anything. I am using a laptop so i only have USB ports. Pat Share this post Link to post Share on other sites
kenimes 42 Posted July 9, 2008 Which COM port is your USB using? Have you verified which one in the Device Manager? Share this post Link to post Share on other sites
Kysmiley 0 Posted July 9, 2008 It's using comm port 4. I set the baud rate and other stuff but did not see where to set the comm port. Pat Share this post Link to post Share on other sites
Kysmiley 0 Posted July 9, 2008 I found that part I just selected usb port instead of blazer usb comm 4. When I tried again I got an error message, I had to restart it to try again Share this post Link to post Share on other sites
kenimes 42 Posted July 9, 2008 Go to Cutter, then Setup. Make sure the USCutter LaserPoint is selected as your cutter, and Blazer COM 4 is your OutPut device. Share this post Link to post Share on other sites
Kysmiley 0 Posted July 9, 2008 Yep thats all done Ken. Thanks for taking time to get me going on this. Pat Share this post Link to post Share on other sites
