engs0062 0 Posted June 12, 2008 Out of nowhere, all of the sudden when I go to cut........the head unit moves in the pattern of the item I am cutting, but it does not drop the blade down to actually cut........worked fine yesterday, I have not done any changes. Any ideas? Thanks Lee Share this post Link to post Share on other sites
kenimes 42 Posted June 12, 2008 Unit is grounded? Is the cutter pulling from a tight roll of vinyl, or have you loosened enough material off of the roll for the job you are cutting? Could be static, or worst case scenario, a carriage going bad. Share this post Link to post Share on other sites
engs0062 0 Posted June 12, 2008 Unit is grounded - and I am using a 10 inch by 20 inch piece of vinyl so it is not even on the roller.......... I un-plugged the cutter and still just goes in the pattern I am cutting without dropping down to actually cut.........cutter is less than a year old. :- Also have jobs waiting to be done...... Share this post Link to post Share on other sites
kenimes 42 Posted June 12, 2008 Test cut from the cutter itself do the same thing? Share this post Link to post Share on other sites
engs0062 0 Posted June 12, 2008 Test cut WORKS! So..........how come it won't work otherwise? Share this post Link to post Share on other sites
kenimes 42 Posted June 12, 2008 Hmmm Not sure....which connection method are you using to connect the cutter to your computer? Share this post Link to post Share on other sites
engs0062 0 Posted June 12, 2008 Using USB....... :- Share this post Link to post Share on other sites
engs0062 0 Posted June 12, 2008 Ok.........this is weird, I have been trying the same file and it would not cut, I tried a different one and it is fine now. Share this post Link to post Share on other sites