cbs1963 0 Posted June 10, 2008 I setup the workspace area to 15 inches by 20 inches, import the files, lay them out on the workspace area, leaving space for a border around the outside of the image. When I go to cut, the image is shown off the cutting area and tile numbers are displayed. What am I doing wrong. I don't see why I should have to tile it. I have vinyl 15 inches wide on a roll. Share this post Link to post Share on other sites
CyberSultan 6 Posted June 10, 2008 I setup the workspace area to 15 inches by 20 inches, import the files, lay them out on the workspace area, leaving space for a border around the outside of the image. When I go to cut, the image is shown off the cutting area and tile numbers are displayed. What am I doing wrong. I don't see why I should have to tile it. I have vinyl 15 inches wide on a roll. In the Cutter view, you need to set the dimensions of the vinyl there as well using the setup button. Share this post Link to post Share on other sites
cbs1963 0 Posted June 10, 2008 Thanks for the help, I was pretty sure it was something I had missed. I appreciate it. Share this post Link to post Share on other sites