ScooterD 0 Posted April 13, 2007 Hi All, First post... OK, so I set up the 2500, load SignCut and can move designs from Corel X3 to SignCut but how do I get them to the cutter? I turn on the cutter, enter "scroll" then what? I'm admitting being an idiot when it comes to learning new equipment, but it doesn't seem like this should be difficult. ANY HELP PLEASE. and go easy on the newbie! Thanks, Scott Share this post Link to post Share on other sites
kenimes 42 Posted April 13, 2007 When you enter scroll, the cutter should read the width of your material. It then tells you the width on the cutter screen. Hit enter again. Now the cutter should be ready to receive commands from your cutting software. You may also select sheet, if you are loading a sheet of material and not using a whole vinyl roll. Then the cutter will read the width AND the length of your material. Open your file to cut in SignCut. Make sure SignCut is setup for the Copam CP-2500 and told which connection you are using. You should then be able to click on file and then cut out. Ken PS- Welcome to our forums! Share this post Link to post Share on other sites
ScooterD 0 Posted April 14, 2007 Thanks Ken! Cutter and computer are like peas and carrots... Scott Share this post Link to post Share on other sites