rlucio210 0 Posted April 5, 2017 I have a MH871-MK2 that wont cut small fonts or good detail. I have set the pressure like all the down, and the cut speed to the lowest. i have tried a 45 degree and a 60 degree blade and nothing. Does anyone have any advice for me? Share this post Link to post Share on other sites
Dakotagrafx 7,293 Posted April 5, 2017 you are trying to go smaller than the capability of the cutter. once you have adjusted the blade like skeeter has mentioned a few hundred times you have covered about everything else you can do - - - 1 Share this post Link to post Share on other sites
