cherise88 4 Posted December 24, 2015 ok i bought a roll of the red SISER EasyWeed Heat Transfer Vinyl, 15" x 5 Yards..... as it is rolled...there is white on the outside and the red is on the inside.... how do i go about cutting a name.... do i cut on the white side or do i cut on the red side?? lost on how to cut... will be using my SC Plotter.... any help will be great...first time doing this.... off to youtube land to search also thank you!! Share this post Link to post Share on other sites
mb20music 760 Posted December 24, 2015 Cut on WHITE side. Cut the name in "Mirror" or "Reverse". 1 Share this post Link to post Share on other sites
mr300s 1,272 Posted December 24, 2015 Yes dont forget to MIRROR or else you will be cutting it again ... Share this post Link to post Share on other sites
cherise88 4 Posted December 24, 2015 Ok thank you... what pressure and speed works the best ?... I make decals at 200 and and pressure 6g.. Share this post Link to post Share on other sites
arty-rc 719 Posted December 24, 2015 The exact pressure varies from cutter to cutter, even the same models. You'll have to find out what pressure works best for your cutter. Slow your speed to very slow until you get the results that you are looking for. Share this post Link to post Share on other sites
pshawny 410 Posted December 24, 2015 I use the same pressure for regular decals and HTV. You might want to adjust the cutting speed depending on the detail in the design. Share this post Link to post Share on other sites
