24warrior 0 Posted April 20, 2008 I just noticed that the white strip on my cutter has cut marks is this bad and can i get a new strip? can anyone help? Share this post Link to post Share on other sites
firemalt 10 Posted April 20, 2008 Some people say to remove the cut strip, flip in 180 degrees and reinstall it. Share this post Link to post Share on other sites
BannerJohn 1,324 Posted April 20, 2008 Some people say to remove the cut strip, flip in 180 degrees and reinstall it. That's what I do, but not until I notice that the wear is affecting the cuts. Share this post Link to post Share on other sites
firemalt 10 Posted April 20, 2008 I beat you could even get away with just rotating it 180 degrees too, if you mainly just do cuts under 12 or so inches. Share this post Link to post Share on other sites
vectorman 0 Posted April 22, 2008 if u flip it it will tear faster 4 2 pcs then if u wont that cutiing strip is only a pice of plastik Share this post Link to post Share on other sites
