artcut settings

[aamotox 0]

Can anyone tell me where the blade offset setting is in Artcut?  I had to re-install the program and now the cuts are not closed.

My cutter is still going haywire in the middle of cutting.  It will just take off and cut a line right up the roll, pretty much ruining my work and vinyl.  Does anyone know what is going on?  I'm getting real frustrated with this thing. 

[kenimes 42]

I think I found it. When you click cut/plot a dialogue box comes up. Click on setup up top in this box and then the plotter compensation tab. Looks like it can be set in there.

[aamotox 0]

I'm guessing close is the offset?  Nothing says offset.

[kenimes 42]

I believe so, I am still learning ArtCut. It is the older software we bundled with our cutters. It is taking some getting used to.