Signlab Version 5 Revision 6.3 instructions for engraving

[L. Johnson 0]

I need help with getting some instructions on signlab 5 rev. 6.3 using with a NH 7200 engraver.  I tried going through Cadlink and they won't support it any longer.  I tried going through DCS (where software was purchased with their 1224 printer) and they won't support it any longer either!!!!!  Any information would be appreciated.  My email is;

loriejoh@irwinresearch.com

or you could come on over and help me out....

Thanks so much

Lorie Johnson