chipperi 45 Posted August 11, 2014 Recently when I cut I am noticing one end of my machine is cutting deeper than the other. My machine is 30" long. The only thing I can think is the bed isn't level?? Any ideas? Share this post Link to post Share on other sites
MadHatterGraphix 1,258 Posted August 11, 2014 check your cutting strip its located inside your cutter where the blade would be cutting over. if there is any scratches or wear and tear on it, it will need be replaced. Share this post Link to post Share on other sites
chipperi 45 Posted August 11, 2014 check your cutting strip its located inside your cutter where the blade would be cutting over. if there is any scratches or wear and tear on it, it will need be replaced. That would make sense the end that is cutting shallow is the end I cut on the most. Share this post Link to post Share on other sites