Bottom of block letters not square

[graphixUlimited 0]

I'm trying to cut some simple labels and using arial black and on the bottom of all the letters the plotter gives it a small little tail. Anyone else having this problem?? Anyone who can help??

[kenimes 42]

Sounds like maybe a speed or offset issue. Try lowering the speed on the cutter a bit and adjusting the offset in the cutter dialoge. It will take some practice and fine tunning before it comes out perfect. Different size lettering and graphics call for different settings which you will come to master over time. If you have scrap vinyl or paper to practice and fine tune with, it will save you from wasting good vinyl.

[graphixUlimited 0]

what should the offset be?

[thredz 1]

Mine is set at  .025,but you can go up to .032 .You might set it at .025 and see if that works.If not just bump it up until you get what you want.