floridakiwi 0 Posted March 15, 2008 My cutter doesn't look like the picture. one piece looks like it has a pen in it. The other one don't look like the picture and I can't figure out how to put the knife in it? Share this post Link to post Share on other sites
BannerJohn 1,324 Posted March 15, 2008 which cutter do you have? That would help. Share this post Link to post Share on other sites
floridakiwi 0 Posted March 15, 2008 Got the knife to fit in the font hole of two on the cutter, but now a can't screw the thing on the side up (knife too fat). It did cut a square with out a problem Share this post Link to post Share on other sites
BannerJohn 1,324 Posted March 15, 2008 the blade holder goes in the back hole. If it doesn't fit,you've done something wrong. AGAIN (for the 3rd time)..WHAT CUTTER DO YOU HAVE??? Share this post Link to post Share on other sites
floridakiwi 0 Posted March 15, 2008 Sorry, using Creation Share this post Link to post Share on other sites
floridakiwi 0 Posted March 15, 2008 Cutter still in front hole, screwed the vinyl up bigtime! I don't get it. Cut a perfect square before, now it's cutting right through everything and screwing up the vinyl. Share this post Link to post Share on other sites
BannerJohn 1,324 Posted March 16, 2008 read this post: http://forum.uscutter.com/index.php/topic,3750.0.html does your blade holder look like that? Is it set up that way? Share this post Link to post Share on other sites
floridakiwi 0 Posted March 16, 2008 Thank you all those that answered. Yes the blade goes in the rear... just takes a bit of forcing... I was scared I might break the thing eh. Would be really good if they mentioned that in the instructions. Anyway, I managed to cut out my first test. Now if only I could get to know how to use the Sign Blazer Program??? That will be tomorrows forum. Share this post Link to post Share on other sites