saaf 0 Posted June 16, 2013 Hello, i had recently got myself a ct630 vinyl cutter, set it up, and just about works perfectly except the blade holder does not move up and down as it should. When i give a design to cut it moves as if to cut but since the blade wont come down and up it wont cut anything. I searched so many places for an answer but haven't found a single solution for this. Could the knife carriage be broken. p.s. this cutter is a new one Share this post Link to post Share on other sites
jaybyrd 3,770 Posted June 16, 2013 My LP2 had a bad carriage new and the tech acted like it was fairly common so if you just bought it I'd be on the phone Monday. Share this post Link to post Share on other sites