babs 0 Posted March 21, 2013 So, I have had my cutter hooked up since 2008 and everything has been fine even when upgrading operating system. Well I just got a new computer installed signcut, drivers, etc... and it sees the cutter and has a com port assigned but the cutter will not jog when I try to set my registration marks. Any ides would be much appreciated. I am just about ready to scream. Thank you in advance. laserpoint 24 windows 8 signcut pro Share this post Link to post Share on other sites
babs 0 Posted March 21, 2013 fixed it reinstalled software and drivers again Share this post Link to post Share on other sites