mebacher 0 Posted October 30, 2012 Good evening. I am at a lost, and have tried all I could think off for 2 day now. I am using FlexiSIGN PRO 10.0.1 with a 50in TC cutter. I am trying to make a very simple cut (a square) The program communicates with the cutter fine, and goes through the motion of cutting EXCEPT that the pen/blade does not go down like it should when it needs to cut or plot. It's almost like the cutter is going through a dry run. The cutter works fine with SignCut PRO. I am using the LIYU TC driver packaged with Flexi. I am connected to a serial port. Any help would be GREATLY appreciated! Thank you. Mike Share this post Link to post Share on other sites