mxracer394 22 Posted July 20, 2012 i have been cutting random stuff the last few days with 12x24 sheets i got...the last two i had left were mactac 8900 pro....when i tried cutting smaller stuff like 3x5 it was looking like crap...would tear spots and when i would weed it the lettering would pull off.. i havent had this issue before. i had the speed at 500 and pressure at 1 and 2g...was it just the vinyl or am i having some issues? Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted July 20, 2012 I would slow it down if it is small letters or graphics and increase the pressure a little you should always do a test cut when you change vinyl and adjust if needed. Dan Share this post Link to post Share on other sites
mxracer394 22 Posted July 20, 2012 i tried it with the speed at 100 and adjusted the pressure some...i dunno what i did to make it different it was cutting small prior to the real slick vinyl...i looked it up and it apparently is wall vinyl Share this post Link to post Share on other sites