Dragonduster 4 Posted June 13, 2012 i need help here, my cutter its leaving A LOT pointy cuts out and sometimes it lift a little vinyl, i changed blade already (my third blade now) and added oil too, pressure was 2g and i changed it back to 25g, speed is 300, what could leave those pointy like spikes on the vinyl? i have cut this dragon before and it cut fine so i know its not the eps i dont know what else i can do =\ blade is 45 grade attached is a photo of the vinyl with those pointy cuts (i dont know how to say it in english, sorry) Share this post Link to post Share on other sites
Ravenwind / One Off Grafx 187 Posted June 13, 2012 try slowing it way down like spd 90 x 90g press Share this post Link to post Share on other sites
Dragonduster 4 Posted June 13, 2012 nop, not working, speed at 100 (increments of 100 up to 800) and 90g pressure, it was cutting fine before Share this post Link to post Share on other sites
Dragonduster 4 Posted June 13, 2012 i pulled in a lot more the blade, now when its cutting, i can hear the holder hit the machine every time it goes down, is this normal? at least it cut a lot better than before, but it still has a little of those pointy cuts going out EDIT: nvm, its too short to cut the vinyl, i need to pull it our a little more =\ Share this post Link to post Share on other sites
Dragonduster 4 Posted June 14, 2012 anyone else with any idea what could be the problem? as how it is now, the cutter is useless now i think the blade is not spinning and thats why its making those cuts, i added oil already with no luck Share this post Link to post Share on other sites