DJPNC 0 Posted May 9, 2012 Hi everyone I'm from France, sorry for my english :-( I use to work Flexisign 5.6 with an old Mac Quadra connected to a Graphtec Plotter FC3100-60. The old Quadra hard disk died and i plug the plotter with a Keyspam to a green EMac. I install the Flexi but a message appears saying: "This application requires that a hardware key and an EvE init extension be installed but one or both of these are not installed..." i confirm that the EvE extension is active on the System Folder but i receive always the same message. Can anybody advice me? Many thanks Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted May 9, 2012 you may need to contact Flexi directly for your older Flexi software, there is a support page, and contac on the website http://www.saintl.biz/ Share this post Link to post Share on other sites
Jay2703 704 Posted May 9, 2012 I'm not a MAC person but could there be drivers for the hardware key that need to be installed on the new machine? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted May 9, 2012 here is the driver site for your USB dongle, if it has one. http://www.safenet-inc.com/technical-support/ Share this post Link to post Share on other sites
DJPNC 0 Posted May 10, 2012 Many thanks I already try to get a solution from Flexi Suport in Europe (Belgium) but they can't advice. the version is too old... they say i work in 2 or 3 possible solutions, i'll post it here when i got one. thanks again Share this post Link to post Share on other sites