winnin67 0 Posted January 24, 2012 guys im sure this question has been asked a million times...but i am a newbie here and very new with vinyl cutters. My fiance and I just play around with it and decorate stuff around the house...anyways we recently purchased it and still getting all the bugs worked out...i have figured almost everything out except this one problem and i just can not figure it out... whenever i cut something it will not finish the letters or connect them back however you want to say it...for example if i was to cut an I..the dot would like almost like a spiral shape... any input is greatly appreciated. thanks! -Chris Share this post Link to post Share on other sites
winnin67 0 Posted January 24, 2012 anything?? would greatly appreciate the help... Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted January 24, 2012 adjust your blade offset.. also make sure blade is barely sticking out of blade holder, take holder out of machine, firmly in your hand cut across a piece of scrap vinyl, should only cut the vinyl and no mark in wax paper backing, put back in machine and use the machine's force to get the same results. Share this post Link to post Share on other sites
winnin67 0 Posted January 24, 2012 what is a good starting point on the offset? sorry for all the questions Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted January 25, 2012 .025mm Flexi inches about .019" Share this post Link to post Share on other sites
winnin67 0 Posted January 28, 2012 ok on the flexi program..where do i go to adjust the offset? as i mentioned before..i am completely new at this Share this post Link to post Share on other sites